For readers · One page

First Gold Panning Trip Checklist

What to bring, the ten-step panning sequence, and how to make sure the creek you picked is open to panning.

What to bring

The panning sequence

  1. Pick the spot. Dig just above bedrock, at the upstream head of a gravel bar, on the inside of a bend, or behind a boulder. Look for black sand.
  2. Classify. Shake material through the screen into the pan. Check the stones, then toss them.
  3. Fill and submerge. Fill the pan level and sink it in still water 6 inches to a foot deep.
  4. Knead. Under water, break up every lump of clay with your hands.
  5. Pick out the stones once they are washed clean.
  6. Shake flat. Hold the pan level under water and shake so the heavy grains settle.
  7. Tilt and swirl. Tilt the pan, raise it quickly under water and swirl, washing the light top layer over the lip.
  8. Repeat. Alternate shaking flat and swirling. Watch that nothing heavy climbs toward the rim.
  9. Slow down at the end. Most gold is lost in the last few swirls. Finish gently, over the tub.
  10. Collect and record. Lift flakes with tweezers, bottle the rest, and write down the place, the amount of black sand and the number of colors, even if it is zero.

Pyrite shatters and mica is light and flaky; gold flattens instead of breaking. Never use mercury.

Is panning allowed here?

Leave it as you found it

The panning steps follow the U.S. Bureau of Mines circular How to Mine and Prospect for Placer Gold (1971) and the USGS study of the gold pan (1957). The equipment and safety notes come from the New Mexico Bureau of Geology's gold panning packet. Land rules were checked on 19 November 2026 against 43 CFR 3809.5 (BLM), 36 CFR 228.4 (Forest Service), 19.2.19.18 NMAC (state trust land) and 19.10.3.300 NMAC (New Mexico Mining Act). The leave-it-as-found rules follow the Prescott National Forest's Lynx Creek panning area. For the full guide, see Gold Panning. More in Treasure.